# Per-target ESP-IDF sdkconfig defaults for esp32p4 static analysis (clang-tidy) only.
# Read by IDF in addition to sdkconfig.defaults. Enables variant-only components so
# their headers register for the tidy translation unit (these are normally set at
# codegen via add_idf_sdkconfig_option, which the stub tidy build skips).

# esp32_hosted (P4 has no native Wi-Fi; it drives a co-processor over SDIO/SPI).
# Mirrors a default SDIO 4-bit setup (slot 1, ESP32-C6 slave) so the esp_hosted
# code paths compile under static analysis.
CONFIG_SLAVE_IDF_TARGET_ESP32C6=y
CONFIG_ESP_HOSTED_SDIO_SLOT_1=y
CONFIG_ESP_HOSTED_SDIO_4_BIT_BUS=y
CONFIG_ESP_HOSTED_CUSTOM_SDIO_PINS=y
CONFIG_ESP_HOSTED_SDIO_CLOCK_FREQ_KHZ=40000
CONFIG_ESP_HOSTED_SDIO_RESET_ACTIVE_HIGH=y
CONFIG_ESP_HOSTED_SDIO_GPIO_RESET_SLAVE=54
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_CLK_SLOT_1=18
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_CMD_SLOT_1=19
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D0_SLOT_1=14
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D1_4BIT_BUS_SLOT_1=15
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D2_4BIT_BUS_SLOT_1=16
CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D3_4BIT_BUS_SLOT_1=17

# BLE runs over the hosted co-processor on P4 (no native BT controller), so
# esp32_ble_tracker must take the hosted bluedroid path instead of <esp_bt.h>.
CONFIG_ESP_HOSTED_ENABLE_BT_BLUEDROID=y

# tinyusb CDC (usb_cdc_acm), same as esp32s3
CONFIG_TINYUSB_CDC_ENABLED=y
CONFIG_TINYUSB_CDC_COUNT=1
CONFIG_TINYUSB_CDC_RX_BUFSIZE=256
CONFIG_TINYUSB_CDC_TX_BUFSIZE=256