diff --git a/esphome/components/uart/uart_component_esp_idf.cpp b/esphome/components/uart/uart_component_esp_idf.cpp
index ea7a09fee60..6c242220a69 100644
--- a/esphome/components/uart/uart_component_esp_idf.cpp
+++ b/esphome/components/uart/uart_component_esp_idf.cpp
@@ -19,13 +19,6 @@ namespace esphome::uart {
 
 static const char *const TAG = "uart.idf";
 
-/// Check if a pin number matches one of the default UART0 GPIO pins.
-/// These pins may have residual state from the boot console that requires
-/// explicit reset before UART reconfiguration (ESP-IDF issue #17459).
-static constexpr bool is_default_uart0_pin(int8_t pin_num) {
-  return pin_num == U0TXD_GPIO_NUM || pin_num == U0RXD_GPIO_NUM;
-}
-
 uart_config_t IDFUARTComponent::get_config_() {
   uart_parity_t parity = UART_PARITY_DISABLE;
   if (this->parity_ == UART_CONFIG_PARITY_EVEN) {
@@ -157,26 +150,20 @@ void IDFUARTComponent::load_settings(bool dump_config) {
   // Commit 9ed617fb17 removed gpio_func_sel() calls from uart_set_pin(), which breaks
   // UART on default UART0 pins that may have residual state from boot console.
   // Reset these pins before configuring UART to ensure they're in a clean state.
-  if (is_default_uart0_pin(tx)) {
+  if (tx == U0TXD_GPIO_NUM || tx == U0RXD_GPIO_NUM) {
     gpio_reset_pin(static_cast<gpio_num_t>(tx));
   }
-  if (is_default_uart0_pin(rx)) {
+  if (rx == U0TXD_GPIO_NUM || rx == U0RXD_GPIO_NUM) {
     gpio_reset_pin(static_cast<gpio_num_t>(rx));
   }
 
-  // Setup pins after reset to configure GPIO direction and pull resistors.
-  // For UART0 default pins, setup() must always be called because gpio_reset_pin()
-  // above sets GPIO_MODE_DISABLE which disables the input buffer. Without setup(),
-  // uart_set_pin() on ESP-IDF 5.4.2+ does not re-enable the input buffer for
-  // IOMUX-connected pins, so the RX pin cannot receive data (see issue #10132).
-  // For other pins, only call setup() if pull or open-drain flags are set to avoid
-  // disturbing the default pin state which breaks some external components (#11823).
+  // Setup pins after reset to preserve open drain/pullup/pulldown flags
   auto setup_pin_if_needed = [](InternalGPIOPin *pin) {
     if (!pin) {
       return;
     }
     const auto mask = gpio::Flags::FLAG_OPEN_DRAIN | gpio::Flags::FLAG_PULLUP | gpio::Flags::FLAG_PULLDOWN;
-    if (is_default_uart0_pin(pin->get_pin()) || (pin->get_flags() & mask) != gpio::Flags::FLAG_NONE) {
+    if ((pin->get_flags() & mask) != gpio::Flags::FLAG_NONE) {
       pin->setup();
     }
   };